To relieve the strain from the terminals of pendants lamp holders and ceiling roses ………….are used.
Cord grip
Underwriter’s knot
Both a & b
None of these
Both a & b
Cord grip and under writer’s knot are used in………….
All of these
Terminals of pendants
Ceiling roses
Lamp holder’s terminals
All of these
In………….the phase or line conductor shall be looped at the switch box and neutral conductors at the point outlets
Looping back method
Looping in method using 2 plate ceiling roses and switches
Looping in method using 2 plate ceiling roses and switches
Joint box method
Looping back method
In the………….method wherever tapping must be taken from cable joints are made
Looping in method using 2 plate ceiling roses and switches
Joint box method
Looping back method
Looping in method using 2 plate ceiling roses and switches
Joint box method
…………. cables are used suitable to run on teak wood battens
All of these
TRS
Tough Rubber Sheathed
PVC sheathed
All of these
………….wiring is used to draw TRS cables on Teak wood
All of these
PVC
Cleat
Batten
Batten
The intervals between wood plugs in batten wiring should at intervals not exceeding………….cm
60
65
75
70
75
………….are used for firmly clipping the cables in position during batten wiring
Link cables
Cable tags
Clamps
Knot
Link cables
Link clips are packed in card board boxes at the rate of ………….link clips per box
100
300
200
500
100
The load on the light and fan sub circuits should be restricted to………
1000 watts
800 watts
600 watts
700 watts
800 watts
पोस्ट अच्छी लगी हो तो प्लीज नीचे दिए गए लिंक पर क्लिक कर शेयर जरुर करें
0 Comments